NEWTON by Intuitive Aerial is a perfect companion for DitoGear VibraFreek. It allows steady shots from a wide range of cameras and lens control systems...

Reduce both high and low frequency vibrations with this Dampening Arm.

This is an accessory for T'rantula HD slider.

This is an accessory for VibraFreek.

This is an accessory for Vibrafreek.

This is an accessory for T'rantula HD slider.

Mount your VibraFreek in an easy way.

The pillar allows for simple vertical positioning of the camera and gimbal rig.

This is an accessory for T'rantula HD slider.

Spinn360 Table Top with multiple mounting holes.

DJI Ronin Mounting Adapter enables attaching a DJI Ronin gimbal to VibraFreek Vibration Dampening Arm.

DitoGear Wedge allows to mount the camera or OmniHead at an angle of 0-90º on DitoGear sliders and 3rd party hardware.

VibraFreek Upgrade consists of four 500 mm arms. Arms are compatible with VibraFreek.

This is an extension track for T'rantula HD.

This is an accessory to VibraFreek Pillar Support Arm

This is an accessory for Trost Motion

A set of wraps for Spinn360 Table.

This is an accessory for Vibrafreek.

Cinevate Lens Geared Rings Pack for DitoGear LensDrive.

VibraFreek Mounting Rods enable mounting the VibraFreek with a Spider Mount to a car's bullbar.

Cinevate Lens Geared Ring for LensDrive.

DitoGear DryEye is a lens heater for your camera. It has been designed to prevent dew condensation or freezing of the camera lenses during long-term shooting...

The DitoGear™ 12V to 8.2V power adapter kit lets you connect the Canon DSLR Camera such as 5D MKII, MKIII, 7D or other cameras using LPE6 battery to any 12V...

VibraFreek HD Springs enable to increase the VibraFreek payload to 38 kg (83.78 lb)

Extra DitoGear Geared Ring for LensDrive.

VibraFreek Counterweight Set 2.5kg enhances the quality of results obtained when shooting with lighter cameras.

DJI Ronin Mounting Adapter Plate is necessary to attach the DJI Ronin Mounting Adapter to XY Module.

This is an accessory for XY Module.

DitoGear Signal Splitter serves as a hub for connecting power, signal and shutter release cables.

Hang your OmniController on any accessories.

Control the DSLR camera from Motion Control Devices.